Ответ (+)


Обсуждение | Ответить | Обновить список
Отправлено: sandy088i 11 Января 2007 г. в 12:00

В ответ на: Кто может подсказать(+) (9К, климат), отправленное Корвалол 11 Января 2007 г. в 11:24

цопирайт не мой :)

The solar sensor is located on the top of the facia. It registers solar intensity but also height and azimuth through the windscreen. In older year models (-1989), only solar intensity is measured.

Solar height is measured between 0°(horizontally) and 90°(vertically). The azimuth reading covers 360°, where 0°is directly forwards, 90°directly to the right etc.

In year model 1995, the solar sensor is powered from pin 5 and transmits a series of pulses back to pin 6 on the Automatic Climate Control (ACC) control module.

These series of pulses are then processed in the control module's microprocessor.

The solar sensor is grounded to pin 35 on the ACC control module.

The solar sensor consists of five solar cells which are soldered to a circuit board which is in turn encased in a plastic box filled with silicone. In earlier year models, the microprocessor was also encased with the sensor. The electronics are now located in the ACC control module.

The sensor is enclosed in a cover of non-scratch plastic. The top side of this cover also functions as a filter and only transmits infrared radiation.

The signal which corresponds to the intensity of solar radiation ranges between 0 - 1390 W/sq.m .

The fact that the solar sensor primarily measures heat radiation means that it cannot be tested using a fluorescent tube. Sunlight or an incandescent lamp must be used.

If there is no data from the solar sensor, a default value of 0 is used.


Обсуждение:



Ответить

Обязательные поля: Имя, Тема, Сообщение

Имя

E-Mail

Тема

Сообщение

Адрес странички

Название странички

Адрес картинки (только .jpg или .gif)


SAAB Board