Вот про него более подробно (+)


Обсуждение | Ответить | Обновить список
Отправлено: Ded-Kiley 13 Ноября 2006 г. в 01:08

В ответ на: Пасиба+, отправленное Andy_CSE 13 Ноября 2006 г. в 01:05

The temperature sensor is located in the intake manifold between the intake manifolds of cylinders 2 and 3 and is in contact with the engine coolant. The sensor is of the NTC type.

The engine control module measures the coolant temperature by applying 5 V to the sensor from pin 68 via an integral 2.74 kohm resistor. The sensor is grounded via pin 67 of the control module.

The ECM receives reference ground from the sensor ground lead to pin 66 to obtain a precise temperature measurement. The voltage across the resistor in the ECM is proportional to the coolant temperature.

The voltage is used to determine fuel injection duration for pre-injection as well as for cold starting and producing a richer fuel/air mixture during the warming-up period. Activation of closed loop and idling speed is also dependent on engine coolant temperature.
In the event of sensor failure or a break in the circuit, the engine control module will set a default temperature that is equivalent to the intake air temperature on starting and then increased by 1°C (1.8°F) every 150th engine revolution.


Обсуждение:



Ответить

Обязательные поля: Имя, Тема, Сообщение

Имя

E-Mail

Тема

Сообщение

Адрес странички

Название странички

Адрес картинки (только .jpg или .gif)


SAAB Board